Signal Tracking Transducer

Overview
The device is a signal tracking transducer. Its output quickly vary with input signal. It works on high-linearity analog optocoupler principle. It can convert AC/DC current/voltage input signal to electrically isolated, standard AC/DC current/voltage signal. Its input, outputs and power supply are electrically isolated from each other. The signal tracking transducer features high accuracy, high isolation, wide frequency band, fast response, low distortion, low drift and wide range of operation temperature. It can filter the common-mode noise generated during the transmission of signals from sensors, transducers or instruments and make a very good isolation and standardization of the signal. The transducer is particularly suitable for acquisition of high-speed transient waveform, harmonic analysis and fast testing and alarm systems. It can be applied widely to various measuring and controlling systems such as communication system, electrical power system, railway and various industrial control systems.

• Case Style: S1, no aperture
• Input: Current :0-1mA ~ 5A, Voltage: 0-50mV ~ 1000V
• Output: (bidirectional) AC/DC current/voltage (isolated)
• Load capability:
  Current output:£500W, Voltage output: 5mA
• Accuracy: 0.2%
• Temperature drift: 250ppm/ ^oC
• Overload: 2 times of full span (1 second, 10 times)
• Response time: 20µS
• 3 db Frequency band: 30kHz
• Isolation voltage: >2500V DC/1 minute
• Power supply: +24V±10%
• Power consumption:1W
• Operating temperature: 0-50 ^oC

1. Please check the part numbers, number of products according to the packing list and labels on the products carefully before use.
2. Please shield the input of the transducer for anti-interference, or, as a result of the fast response of the transducer, the noise carried by input signal may affect the output.
3. Please make sure to connect input, output and power supply correctly in accordance with the connection diagram of your part number before power on.
4. Conductive dust and corroding gases may damage the circuit and connections. They are hazardous to the product. Don’t operate in that environment.
5. Please ensure the terminal screws are tightened securely and reliably before measuring with probes of meters directly on the terminals.
6. If more than one transducers are mounted together, keep a space more than 10mm between adjacent units.
7. The transducer has been calibrated before delivery. Please contact the company if readjustment is required.
8. Don’t disassemble the standard signal isolator. Please avoid impact or falling down from a high place. Do not remove or damage the labels on the product.
9. Please take additional and reasonable means for lightning protection, especially when the input and output wires of the transducer are exposed outdoor.