| Company
Profile |
| Certificate |
 Current Transducer |
| Voltage Transducer |
| Power Transducer |
| Frequency Transducer |
| Multi-parameter Transducer |
| Other |
|
Select Guide for Transducer with Analog Output |
|
Select Guide for Transducer with Digital Output |
|
Select Guide for Transducer with LED Display |
|
Select Guide for Hall Effect Sensor |
| Software Download |
| Connection of RS-485/232 Converter |
| System Connecting For Transducer with Digital Output |
Application and Programming for Transducer with Digital Output |
| Transducer with Analog Output |
| Transducer with Digital Output |
| Transducer with LED Display |
| Hall Effect Sensor |
| Vehicle Detector |
| Notices to Users |
| Notices for Installation |
| FAQ For Transducer with RS485 Digital Output |
| FAQ for Transducer with Analog Output |
| Product Knowledge |
| AC 1-element |
| AC 2-element |
| AC 3-element |
| DC |
| AC 1-phase |
| AC 3-phase 3-wire |
| AC 3-phase 4-wire |
| DC |
| AC 1-element |
| AC 3-phase 3-wire |
| AC 3-phase 4-wire |
| AC 1-element |
| AC 3-phase 3-wire |
| AC 3-phase 4-wire |
| AC 3-phase 4-wire, multi-cross |
| Power Factor Transducer |
| Standard Signal Isolator |
| Resistance Transducer |
| Potentiometer Transducer |
| Switch Values Data Logger |
| Ethernet Converter |
| Power Source |
| Vehicle Detector |
| Current Transducer |
| Voltage Transducer |
| Power Transducer |
| Frequency Transducer |
| Other |
| Multi-parameter Transducer |
| Current Transducer |
| Voltage Transducer |
| Multifuction Transducer |
| Current Transducer |
| Voltage Transducer |
| Case A Transducer |
| Case B Transducer |
| Case C Transducer |
| Case D Transducer |
| Case E Transducer |
| Case F Transducer |
| Case LX Transducer |
 0-55Hz~5KHz |
|
|
| System Connecting |
Home >> Technical Support >> System Connecting |
|
When series CE-A intelligent electric isolation Transducer are
applied in measuring and controlling system, the RS-485 system connecting
diagram is as follows:
|
|
Series CE-A intelligent electric isolation transducer is able
to communicate with all kinds of computers by appropriate connecting.
The connecting method: connect pin "DATA+" of D485(RS-232/RS-485)
converter of the computer with the pins "DATA+" of all Transducer,
connect the pin "DATA-" of that of computer with pins "DATA-"
of all Transducer, and put resistance terminators (120W)
at the two ends [it is not necessary when the distance is closer (£1200m)].
Then connect to the POWER SOURCE. The measurements can work with running
application software of the sensor/transducer in the computer.
|
| |
|
|
Service 
